Summary:
Implementation in accept4 is special, the requested newsock is saved as filep->priv. This will cause sock_file_close to use fs_heap_free filep->priv during close. When fs_heap is configured, the released memory will not be on fs_heap, causing a crash.
Signed-off-by: chenrun1 <chenrun1@xiaomi.com>
If arp search fails once, subsequent searches for the ip will directly
return failure, and sends an asynchronous arp request to try to update
arp table in the future. In this way, the psock_sendmsg interface will
not block for a long time each time because arp cannot be obtained.
This scenario is triggered when a udp socket frequently attempts to
access an ip address that does not exist on the LAN.
Signed-off-by: zhanghongyu <zhanghongyu@xiaomi.com>
Summary:
The conn->keeptimer units is decisecond，but its unit is treated as
half-second in the tcp_timer & tcp_get_timeout function.
Therefore conn>keeptimer needs to be divided by 5(DSEC_PER_HSEC)
to match half-second units.
Signed-off-by: zhangshuai39 <zhangshuai39@xiaomi.com>
detail: Add g_ prefix to can_dlc_to_len and len_to_can_dlc to
follow NuttX coding style conventions for global symbols,
improving code readability and maintainability.
Signed-off-by: zhaohaiyang1 <zhaohaiyang1@xiaomi.com>
Revert "Parallelize depend file generation"
This reverts commit d5b6ec450f.
parallel depend ddc does not significantly speed up compilation,
intermediately generated .ddc files can cause problems if compilation is interrupted unexpectedly
Signed-off-by: xuxin19 <xuxin19@xiaomi.com>
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
According to rfc1112, section 7.2:
"An ICMP error message (Destination Unreachable, Time Exceeded, Parameter Problem, Source Quench, or Redirect) is
never generated in response to a datagram destined to an IP host group."
Signed-off-by: zhangshuai39 <zhangshuai39@xiaomi.com>
We can see them in ifconfig:
ap> ifconfig
wlan0 Link encap:Ethernet HWaddr 42:64:7f:b3:12:03 at UP mtu 1500
inet addr:10.0.1.2 DRaddr:10.0.1.1 Mask:255.255.255.0
inet6 DRaddr: ::
RX: Received Fragment Errors Bytes
00000b9b 00000000 00000000 21daf5
IPv4 IPv6 ARP Dropped
00000a33 00000137 00000031 00000000
TX: Queued Sent Errors Timeouts Bytes
00000ac4 00000ac4 00000000 00000000 1a2103
Total Errors: 00000000
Signed-off-by: meijian <meijian@xiaomi.com>
SO_SNDBUF takes effect only after the connection in STREAM mode
is successful
support full life cycle modification of SO_RCVBUF
Signed-off-by: zhanghongyu <zhanghongyu@xiaomi.com>
when tcp socket stays in TCP_FIN_WAIT_1 or TCP_FIN_WAIT_2,not actively calling tcp_close_eventhandler,can reuslt in some TCP socket being set to a closed state,but nofosegs are not directly released,leading to IOB resource leakage.
Signed-off-by: wangchen <wangchen41@xiaomi.com>
If the device's CPU resources are scarce and unable to execute the
ip_fragin_timerwork callback in a timely manner, this assert will
be triggered. This is a normal scenario that can occur. The logic
should be modified to wait for the ip_fragin_timerwork to be
executed if it has not been executed yet.
Signed-off-by: zhanghongyu <zhanghongyu@xiaomi.com>
1. Tcp will idle loop by tcp_timer when have no packet to send. This will cause low-power devices to be frequently woken up.
2. We should add tcp_timer when timer has been canceled and have packet to send.
Signed-off-by: meijian <meijian@xiaomi.com>
For udp localsocket current implementation,the sent information only carries the packet info.
The receiver receives the information,it don't know who the information comes from.
Thus the receiver doesn't know who to send the response message to.
We add sender's binding path info in the information,the receiver knows who sent the information
based on the parsed information.
The receiver knows who to send the response message to.
Signed-off-by: wangchen <wangchen41@xiaomi.com>
./build.sh sim:usbdev -j12
sudo gdb nuttx/nuttx -ex "source nuttx/tools/gdb/__init__.py"
below command to create mbim NIC on host
nsh> conn 3
NuttX's MBIM device implementation adds an additional MBIM network
card to the NuttX system, which can debug the data communication with
the host, but this network card is unnecessary and needs to be removed
when the business actually uses this driver, And the cdcncm_receive
method needs to be re-implemented.
Signed-off-by: zhanghongyu <zhanghongyu@xiaomi.com>
